Swiss rent calculator: reduction and increase based on the reference interest rate

Apartment building with wooden balconies in a Swiss residential area

In short: With the rent calculator you can work out how much a rent may fall or rise after a change in the reference interest rate, offset against inflation and general cost increases. It follows the pass-through rates under Art. 13 VMWG referred to by the Federal Office for Housing (FOH).

Calculator

Rent calculator: reference rate, inflation, costs

Reference rate
–
Inflation (40 %)
–
Cost increase
–
Total
–

New rent –

For guidance only, not legal advice. Reservations from earlier adjustments, the objection of an insufficient net return and the practice of the conciliation authority can change the result.

How the rent calculator works

The calculator combines the three reasons why a rent may move after a change in the reference interest rate. Each share is calculated as a percentage of today's net rent, and the shares are then added together.

  • Reference rate: for every 0.25 percentage points, the rent may rise by 3 %. If the rate falls, tenants are entitled to a reduction calculated back from the higher rent: 2.91 % for one step (derived from Art. 13 VMWG).
  • Inflation: the landlord may offset 40 % of the change in the Swiss consumer price index since the last adjustment.
  • General cost increases: a flat rate per year, pro rata for the months since the last adjustment. The level of the flat rate depends on the practice of the conciliation authority and varies from canton to canton.

What always counts is the reference rate that applied when the rent was last set. It is stated in the lease or in the last notice of a rent change. You will find the current rate and its development since 2008 on our page on the current reference interest rate.

Worked example: reduction with inflation and costs

A net rent of CHF 2000 per month is based on a reference rate of 1.75 %. Today 1.25 % applies, and the last adjustment was 24 months ago. As an example we assume inflation of 2.0 % and a cost flat rate of 0.25 % per year (usual in the canton of Zurich when service charges are billed separately; elsewhere often 0.5 to 1 %).

ShareCalculationResult
Reference ratefrom 1.75 % to 1.25 %, 2 steps: 1 − 1 / 1.06−5.66 %
Inflation40 % of 2.0 %+0.80 %
Cost increase0.25 % × 24 / 12 months+0.50 %
Total−4.36 %
New rentCHF 2000 × (1 − 4.36 %), rounded to 5 centimesCHF 1912.80

In this example the tenants are entitled to a reduction of CHF 87.20 per month. Without offsetting inflation and costs it would be CHF 113.20. The values for inflation and the flat rate are assumptions for the example, not the current figures.

Which reference rate applied when?

Use this table to find the rate a rent is based on if it is missing from the lease: what counts is the value that applied on the day of the last rent setting.

Valid fromReference interest rate
10.09.20083.50 %
03.06.20093.25 %
02.09.20093.00 %
02.12.20102.75 %
02.12.20112.50 %
02.06.20122.25 %
03.09.20132.00 %
02.06.20151.75 %
02.06.20171.50 %
03.03.20201.25 %
02.06.20231.50 %
02.12.20231.75 %
04.03.20251.50 %
02.09.20251.25 %

Source: Federal Office for Housing (FOH).

Reference interest rate since 2008Reference interest rate from 3.50 % as of 10.09.2008 to 1.25 % as of 02.09.2025, 14 values, lowest value 1.25 %, highest value 3.50 %.1.00 %1.50 %2.00 %2.50 %3.00 %3.50 %201020122014201620182020202220242026
Reference interest rate since 2008, currently 1.25 % since 02.09.2025, Source: Federal Office for Housing (FOH)

Reduction and increase: the rates at a glance

For several steps, the pass-through rates referred to by the FOH apply. The increase grows by 3 % per step, and the reduction is calculated back from it.

ChangeIncreaseReduction
0.25 points3.00 %2.91 %
0.50 points6.00 %5.66 %
0.75 points9.00 %8.26 %
1.00 points12.00 %10.71 %
1.25 points15.00 %13.04 %
1.50 points18.00 %15.25 %

The 3 % per quarter percentage point applies as long as the reference rate is below 5 %. Above that, Art. 13 VMWG provides for smaller steps.

Form and timing of the adjustment

  • Increase: the landlord must notify it on the officially approved form (Art. 269d CO), and it takes effect at the earliest on the next termination date.
  • Reduction: the tenants request it in writing from the landlord (Art. 270a CO), and it too only takes effect on the next termination date.

What the calculator does not take into account

  • Reservations from earlier adjustments: if the landlord reserved a quantified increase, it can claim it later. More on the page on the rent reservation.
  • Objection of insufficient net return: the landlord can refuse a reduction if the property does not generate an excessive return at today's rent (Art. 269 CO).
  • Other reasons for an adjustment, such as value-enhancing investments or customary local rents.
  • Indexed and graduated leases: the reference rate does not apply to them.
  • The practice of the cantonal conciliation authorities, for example on the level of the cost flat rate.

Process for property managers

After a change in the reference rate, a property manager calculates not one rent but hundreds. A fixed process has proven itself: filter the leases affected by the rate at the last rent setting, calculate each lease with inflation and costs, answer reduction requests within 30 days and inform all tenants proactively.

How this works in detail is explained in our guides on rent reduction and rent increase. To inform all tenants in one step, there is Allthings digital tenant communication.

Sources

  1. Federal Office for Housing (FOH): mortgage reference interest rate
  2. HEV Schweiz: pass-through rates for the reference rate (linked by the FOH), accessed on 4 November 2026
  3. Ordinance on the Lease of Residential and Commercial Premises (VMWG), Art. 13, 16 and 18
  4. Swiss Code of Obligations (CO), Art. 269d and 270a

Information as of 13 November 2026.

FAQ

Frequently asked questions

How do I calculate a rent reduction based on the reference rate?

Take the reference rate at the last rent setting and compare it with the current one. Each 0.25 percentage point difference gives a reduction claim of 2.91 %, calculated back for several steps (0.50 points = 5.66 %). The landlord deducts inflation and cost increases from this.

How much may the rent rise when the reference rate increases?

3 % per 0.25 percentage points, as long as the reference rate is below 5 %. Inflation and general cost increases are added if they have not been offset since the last adjustment.

Why is the reduction smaller than the increase?

The reduction is calculated back from the higher rent: 1 − 1 / 1.03 = 2.91 %. An increase of 3 % and a reduction of 2.91 % thus lead back to the same rent. The 3 % is set out in Art. 13 VMWG; the 2.91 % is derived from it.

Which inflation may be offset?

40 % of the change in the Swiss consumer price index since the last rent adjustment.

Is the result binding?

No. The calculator is for guidance. Reservations, other reasons for adjustment, the objection of insufficient net return and the practice of the conciliation authority can change the result. In a dispute, the conciliation authority is responsible first.

Does the calculator apply to all leases?

No. The reference rate does not apply to indexed and graduated leases, nor to apartments whose rents are controlled by an authority.

Easy. Pragmatic. Swiss. This is how real estate business works today.

Book an appointment now
Customer login
Next
Contact

Contact the Allthings team

Our team usually answers within 24 hours.

Fill out the contact form

We process your data to answer your request. For more details, see our privacy policy.

Submit
Thank you! We will get back to you shortly.
Something went wrong while sending. Please try again or write to info@allthings.me.